You're viewing a previously published revision of this guide.  View latest revision

Older
Jan 27, 2015 - 06:01:51
Feb 25, 2015 - 02:02:35 Feb 25, 2015 - 02:02:32 Feb 25, 2015 - 12:02:13 Feb 25, 2015 - 12:02:06 Feb 25, 2015 - 12:02:49 Feb 25, 2015 - 12:02:27 Feb 25, 2015 - 12:02:40 Feb 25, 2015 - 12:02:13 Feb 25, 2015 - 12:02:48 Feb 24, 2015 - 02:02:42 Feb 24, 2015 - 02:02:40 Jan 27, 2015 - 06:01:49 Jan 27, 2015 - 06:01:19 Jan 27, 2015 - 06:01:03 Jan 27, 2015 - 06:01:31 Jan 27, 2015 - 06:01:31 Jan 27, 2015 - 06:01:44 Jan 27, 2015 - 06:01:44 Jan 27, 2015 - 06:01:27 Jan 27, 2015 - 06:01:51 Jan 27, 2015 - 06:01:51 Jan 27, 2015 - 06:01:33 Jan 27, 2015 - 06:01:33 Jan 27, 2015 - 06:01:14 Jan 27, 2015 - 06:01:55 Jan 27, 2015 - 06:01:55 Jan 27, 2015 - 06:01:40 Jan 27, 2015 - 06:01:40 Jan 27, 2015 - 06:01:03 Jan 27, 2015 - 06:01:03 Jan 27, 2015 - 05:01:33
Newer

Disk grinding/polishing

Written By: Low Jun Hua
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

Flags

2

In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Private

Private

This guide will not appear in search results and can only be viewed by team members!

    • This would make it easier to place the sandpaper on the surface of the disk for grinding.

    • As sandpapers come in different sizes, cut them to a strip small enough to be placed on the disk but yet big enough to be handled with your fingers.

    • Desktop -> NUS_Tribometer 3 -> Tribometer_Start-Up.vi -> Run -> Production Test -> Test Panel

    • Ensure that the hanging mass has already been removed so that it will not lower the cantilever beam and activate the load cell.

    • The gloves will prevent any debris on the disk from being transferred onto your hand(s) during disk grinding.

Author

Low Jun Hua

Member since: 1/23/14

3,901 Reputation

37 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 24